cwrest.blogg.se - Setting up credit card terminal

Input the numbers listed beside “SEC DNS” in the print out that you generated earlier.

Select DNS Setup, then select “SEC ADDRESS”.

Input the numbers listed beside “PRI DNS” in the print out that you generated earlier.

Press the red button to go back, then Select DNS Setup (found under Terminal Setup), then select “PRIM ADDRESS”.

Press the green button once you enter this, then press the red button once.

Select Port Number, make sure it is set to “5555”.

If the numbers are the same then no action is needed.

Select Gateway, input the “Gateway” listed on the print out that you made.To add periods just press 0 followed by the (.,#*) key.

Select Mask ID, input the “Mask ID” listed on the print out that you made.To add periods just press 0 followed by the (.,#*) key.Select Terminal Addr, input the “ADDRESS” listed on the print out that you made.To add periods just press 0 followed by the (.,#*) key.We need to make sure the terminal is configured correctly, to do this we will input the data from the trailer receipt into the terminal Press the red button until you’re back at the home screen.You will need to put your terminal into Semi-Integrated mode eventually but before that the network address type needs to in static. There is no internet coming from the ethernet port, in this case you would need to contact your internet service provider. Your ethernet cable is faulty, replacing the cable would solve the issue.ģ. Your ethernet cable is not connected properly to the terminal, ethernet port, or both.Ģ. Note: the section that says “Address" is your IP address. If IP address is 0.0.0.0 there is no ethernet connection which could be for one of three reasons:ġ. It will print for a while and then you will see fields such as: MAC Address, Address, Mask ID, Gateway.Type in the number “16” when it asks you to enter the Admin Code.Press (.,#*) again, the terminal will as you to enter the admin code.Press the Admin menu (.,#*) and wait a second or two.You need to make sure you have all the information you need in order to proceed through the installation. Note: Your terminal may restart several times during this process, this is normal behaviour If you don't call them you won't be able to set up the machine, their assistance is necessary. This is only if you have a brand new out of the box terminal or you have switched payment processors. Once this is done, please call your payment processor (Moneris, Global Payments or Merrco) in order to set up merchant settings for you. Ensure that you plug the ethernet cable into the slot labeled “ETH” Make sure that the terminal is plugged into the power bar and ensure that an ethernet cable is running from your router into the credit card terminal box.

Step 1: Unbox and Set Up Plug in the Hardware Credit Card Terminal Set Up - Moneris ICT250